Ion-audio Replacement Belt Manual do Utilizador descarregar pdf

ION Turntable Belt Replacement Guide

To re-attach a turntable belt on your ION turntable, follow the procedure below:

1. Disconnect the power cable from the turnable.

2. Remove both the record, and the slipmat from the turntable.

3. There is a clip located over the middle of the spindle. You will need to remove

this clip before you can take off the platter. A flathead screwdriver can be used

to gently push the clip off the middle spindle.

4. Remove the platter by pulling it straight up, and over the spindle.

5. Place the platter upside down on a flat surface and position the belt so that it is

wrapped around the underside of the platter’s inner ring, centered straight and

free of any twists.

1 2

Página 1

1 ION Turntable Belt Replacement Guide To re-attach a turntable belt on your ION turntable, follow the procedure below: 1. Disconnect the power

2 6. Use your thumb to carefully lift part of the belt up while placing the belt over the brass motor spindle, while aligning the platter back ont

Sem comentários

Ion-audio Replacement Belt Manual do Utilizador